TSB: 09-003/02

1999-2000 PROTEGE - REAR DOOR WEATHERSTRIP COMES OFF

NOTE: This bulletin replaces 09-004/99. Please update your records accordingly.

BULLETIN NOTE

This bulletin supersedes S004/99 and 09-004/99 issued 3-17-1999. The APPLICABLE MODEL(S)/VINS have changed.

APPLICABLE MODEL(S)/VINS

All 1999-2000 Proteges

DESCRIPTION

Placing your hand on the rear door frame while entering or exiting the vehicle may cause the weatherstrip to pull out of its channel. All applicable vehicles should be inspected and repaired using the following procedure.

REPAIR PROCEDURE

1. Detach the weatherstrip from the top/side portion of the door as shown.

2. Clean weatherstrip and its channel with isoprophyl alcohol.

3. Apply a 1/4 inch bead of clear RTV silicone in the weatherstrip channel.

4. Reinstall weatherstrip into the channel and apply pressure to the affected area. Make sure that the silicone makes even contact with the weatherstrip.

NOTES:

• Verify weatherstrip is completely inserted into the channel.

• Check weatherstrip at belt line for a firm fit against door frame, if necessary slide weatherstrip upward to remove slack.

5. Remove any excess silicone.

NOTE: Weatherstrip must not be disturbed for at least 24 hours.

WARRANTY INFORMATION

Note: This information applies to verified customer complaints on vehicles covered under normal warranty. Refer to the SRT microfiche for warranty term information.