09-004/05 2004-2006 MAZDA3 - STAINS ON PAINT

BULLETIN NOTE

• This bulletin supersedes the previous bulletin issued on 02/18/05. The APPLICABLE MODEL(S)/VINS information has been revised.

APPLICABLE MODEL(S)/VINS

2004-2006 MAZDA3

DESCRIPTION

Paint stains may be present on the hood, roof, and/or trunk after removal of RAPGARD material. The concern may be more noticeable in areas of cold ambient temperatures. This is caused by moisture trapped between the paint and RAPGARD.

Vehicles having this concern should use the following repair procedure.

REPAIR PROCEDURE

The following procedure requires a 1000W (100V AC) heat gun.

NOTE:

• This repair procedure requires hot air. Before getting started on the repair, be sure to remove rubber parts or other parts which are easily affected by heat in the surrounding areas.
• Use extreme care to maintain a surface temperature below 140 C (284 F).

1. Place heat gun approximately 5 cm (2 inches) from stained surface for 20 seconds.

2. Then move heat gun approximately 10 cm (4 inches) from stained surface and apply heat for a maximum of 20 minutes. Use a slow, back and forth motion to control heat.

   NOTE: Do not apply heat for longer than 20 minutes, or surface damage may occur.

3. If the above steps do not remove the stains, refinish the affected surface(s).

WARRANTY INFORMATION

NOTE:

• This warranty information applies only to verified customer complaints on vehicles eligible for warranty repair. Refer to the SRT microfiche for warranty term information.
• Additional diagnostic time cannot be claimed for this repair.